🚌 LUVbus

the Ethereum batch rail — every seat receives, one transaction drives

origin: the first multi-send test ran on the abandoned Polygon test contract (MultiSend) — LUVbus is what that test became, live on Ethereum, where 1 LUV == 1 LUV in every seat

the bus · address & connection

LUVbus contract address (set after deployment)

chain— connected— owner— pending owner— operator gate— paused— retired (one-way)— maxBatchSize— LUV default / seat— bus LUV balance— bus ETH balance—

diagnostics & ABI ✓ read contract write contract

buy LUV

Reads use your wallet's provider (no third-party RPC leaves this page). The full read/write ABI surface lives on Etherscan — this console carries the batch and admin controls. Remember: the token owner should setFeeExemption(bus, true) so every seat receives the full amount — 1 LUV === 1 LUV.

board the bus · ERC20 batch (LUV preset)

token address mode amount (LUV, 18dp · uniform=per seat, split=total; ignored for default/variable)

recipients — one per line (variable mode: address,amount)

native ETH batch

mode amount (ETH, 18dp) fund with tx value (ETH; sent along, optional)

recipients — one per line

admin · owner only

maxBatchSize default LUV / seat (18dp)

transfer ownership to (two-step; receiver must accept)

withdraw LUV — to, amount (18dp)

one-way switches — type RETIRE or RENOUNCE to arm

RETIRE flips the one-way binary switch: pause goes ON permanently, no unpause exists, withdraw/recover stay live. RENOUNCE kills every owner function including withdrawals — sweep the bus first.